We stock all types of oscilloscope accessories, for rental and sale. We are located in Monterrey, NL.
The high-performance P6204 and P6203 active probes complete the capabilities of the 11000-Series oscilloscopes and plug-ins.
The P6204 is a 1 GHz, high-impedance (high input R, low input C), miniature-size, 10X active (FET) probe for use in high-speed digital and analog circuits. The variable DC offset voltage (±10 V) is adjustable through mainframe controls, allowing you to compensate for any DC component within the range of the control. This lets signals with DC components be placed within the dynamic range of the probe.
Although designed primarily for the 11A52 and 11A71 plug-ins, the P6204 can be used with the other 11000-Series plug-ins.
The 50-ohm termination required by the P6204 is accommodated automatically by the 11000-Series mainframe. When an 11000-Series active probe is connected to an input connector of an 11A32, 11A33 or 11A34 Amplifier plug-in unit, the plug-in input impedance automatically changes to 50 ohms.
The P6204 active probe has a button that, when pressed, causes one or more of several actions to be taken by the mainframe. These actions include autoset, recalling the next in a series of stored setups, invoking the automatic measurement function, or issuing an SRQ. These actions can be selected through the mainframe utility menu.
The P6204 active probe provides communications (intelligent probing) through the TekProbe™ interface connector. The probe can (if available on the specific probe) communicate one or more of the following to and from the host instrument: its type, serial number, attenuation ratio, input impedance, offset scale factor, and other key parameters. Power for the active probes is also supplied through the TekProbe™ interface, eliminating the need for additional cabling and external power supplies.
The P6204 can also be used with other oscilloscopes via the 1.103 TekProbe BIA power supply.
QUICK SPECIFICATIONS
Bandwidth: DC to 1 GHz
Rise time: < 350 ps
Attenuation: 10X
Input resistance: 10 MΩ
Input capacitance: approx.
1.9 pF
Input range resistance: 50 Ω
Pin readout: Yes
ID button: Yes
Max. rated voltage: 40 V DC
Discontinued 01/11/2000
High-safety AC current clamps with BNC output
An add-on for your oscilloscope or power quality meter that lets you measure up to 400 A AC.
Only current clamps with a CAT IV 600 V / CAT III 1000 V safety rating are available.
Special design for maximum functionality in minimum space.
Take accurate current readings without interrupting the circuit.
Ergonomic design with a soft non-slip coating.
PM9081/001 BNC/banana adapters for digital multimeters.
Two ranges: 40 A and 400 A output, 10 and 1 mV/A.
Maximum conductor diameter: 32 mm.
